FactionFab Brake Upgrade Kit. This kit includes new rotors, brake pads, and stainless steel brake lines to improve the braking performance of your vehicle.
REAR LOCATION
FITMENT NOTE: This is for models WITHOUT the brembo package, and WITH the vented rear rotor.
FACTIONFAB SWEPT SLOT BI-DIRECTIONAL ROTOR PAIR REAR
Rear location
Shallow Sharp-edged groves are milled into a high carbon cast iron disc to provide consistent pad contact and maximum friction over repetitive use
High-carbon content for wear resistance, thermal stability, and cracking resistance
Bi-directional design, meaning rotors are not side specific
Symmetric vane castings to increase heat dissipation efficiency and thermal stability
Double-disc ground, non-directional finish
Mill balanced for reduced vibration
Precision machined with run-out spec of no more than .002", Disc Thickness Variation (DTV) of .0005"
Fully machined non-friction surfaces for perfect fitment
Sold as a pair
Electronically applied E-coating for corrosion resistance
400-hour salt spray tested
Fully coated inside and out
FACTIONFAB F-SPEC REAR BRAKE PADS
Rear location
Para-Aramid Composition
Ideal for auto-x, light track days, or aggressive street driving
1300ºF maximum operating temperature to aid in fade resistance
Excellent modulation and initial bite
Pre-scorched compound to aid in cold weather modulation
O.E. gas slots and chamfers ensuring for safe efficient stopping while reducing noise associated with vibration
Positive molded technology provides safe and reliable stopping performance for the entire service life of the brake pad
Positive molded technology manufacturing process uses extreme pressure to compress the friction material and drives out any impurities or excess resins found in the brake pad
Precision cut backing plates ensure correct pad fitment in the caliper body eliminating vibrations and noise under braking
Mechanically attached application specific pad shims are designed to eliminate noise associated with brake pad vibrations
FACTIONFAB STAINLESS STEEL BRAKE LINES
Rear location
PTFE Teflon inner liner to carry the fluid
Stainless steel woven middle layer for support of the inner liner
Abrasion-resistant, impact-resistant
Outer PCV clear abrasion resistant coating to aid in chaffing and protects the inner layers and stress relief at fitting locations
Each line is 4500psi burst pressure tested
Stainless steel precision machined fittings for perfect fit and corrosion resistance
Increased pedal feedback as a result of elimination of soft rubber lines which are prone to swelling and deforming
100% model specific for perfect fitment
Includes hardware